Sortimo SR5 User Manual

© Sortimo International GmbH MA 00057 | 2022-01-11 | 5 102
How to attach the racking
Determining the number and position
An EcoFiX bracket is attached in either a pull or push direction. A
block system needs to be secured in place in both directions. Up
to three areas are defined depending on the grid height of the
block system. Rules are defined below for these areas.
Rule Position the EFI as high as possible in each area.
120
90
60
0
Grid height
Direction of travel
Push direction
Pull direction
Field
In the Grid 0 to grid 60 area ...
• Each profile must be connected by an EFI bracket in the pull direction.
• At least one profile must be connected by an EFI bracket in the push direction.
In the Grid 61 to grid 90 area ...
• Each profile should be connected by an EFI bracket in the pull direction.
• There may be at most one profile without an EFI bracket in the pull direction.
• At least one profile must be connected by an EFI bracket in the push direction.
In the Grid 91 to grid 120 area ...
• Each profile should be connected by an EFI bracket in the pull direction.
• There may be at most one profile without an EFI bracket in the pull direction.
• At least one profile must be connected by an EFI bracket in the push direction.

Sortimo SR5 Specifications

General

Brand	Sortimo
Model	SR5
Category	Tool Storage
Language	English