How to fix a Sotera Measuring Instruments meter that won't turn on?
If your Sotera Measuring Instruments meter won't turn on, it could be due to dead batteries or a damaged electronics module. Try replacing the batteries first. If that doesn't work, replace the electronics module and gaskets.
What does a flashing decimal mean on my Sotera 825P?
If you see a flashing decimal on your Sotera Measuring Instruments, it means the current total has rolled over. Reset the display to zero by pressing button 2.
Why is my Sotera 825P meter reading low?
If your Sotera Measuring Instruments meter reads low by 10% or less, the calibration factor might be wrong. Use a lower calibration factor to resolve this.
What causes a Sotera Measuring Instruments meter to read low by more than 10%?
If your Sotera Measuring Instruments meter reads low by more than 10%, the meter chamber may be worn, partially plugged, or damaged. Try cleaning the chamber, or replace the chamber and recalibrate the meter.
Why is my Sotera 825P Measuring Instruments meter inconsistent?
Inconsistent readings on your Sotera Measuring Instruments meter can be caused by air in the system, particulates in the fluid, or a worn or damaged meter chamber. Prime the system and fix any suction leaks at the pump. Install a screen in front of the meter. Clean the chamber. Replace the chamber.
Why does my Sotera 825P Measuring Instruments meter read high?
If your Sotera Measuring Instruments meter reads high, there may be air in the system or the calibration factor is wrong. Prime the system and fix any suction leaks at the pump. Alternatively, use a higher calibration factor.
How to stop Sotera Measuring Instruments from leaking at the port?
If you notice fluid leaking at the inlet or outlet port of your Sotera Measuring Instruments, it could be due to the need for thread sealant or a cross-threaded port. Try adding Teflon pipe tape to the joint. If the leak persists, replace the body.
What to do if fluid flows but Sotera 825P Measuring Instruments meter won't count?
If fluid is flowing, but your Sotera Measuring Instruments meter isn't counting, the meter disk might be sticking, or the driver or magnet could be damaged, or the meter might have failed. Try cleaning out the meter chamber. If that doesn't work, repair or replace the chamber assembly, or repair or replace the meter.
Why is the display flashing on my Sotera Measuring Instruments?
A flashing or dim display on your Sotera Measuring Instruments meter usually indicates low batteries. Replace the batteries to resolve this issue.
General| Brand | Sotera |
|---|---|
| Model | 825P |
| Category | Measuring Instruments |
| Language | English |
Explains danger, warning, and caution symbols and their meanings.
Describes the 825P/850P meters as nutating disk positive displacement meters using magnetic coupling.
Tips to prevent cross-threading when installing the meter into threaded joints.
Step-by-step guide to reposition the meter's electronics module for optimal viewing.
Steps to adjust the calibration factor by pressing specific buttons.
Detailed steps for setting the CAL factor, priming, and adjusting the meter's reading.
Instructions for safely replacing the meter's batteries, including cautions.
Procedure for cleaning a meter that is plugged due to hardened chemical or debris.
How to select and set pulse output configurations for different units of measure.
How to display the current flow rate and its relation to output signals.
Instructions for changing the meter's displayed unit of measure.
Steps to set up custom units of measure based on ounces per special unit.
How to reset the accumulated total on the meter display.
Procedure to check the meter's calibration by verifying pulse counts.
How to flush the meter without adding to the totalizer using the FLSH mode.
To Next Page
