Why does my Sotera 825 Measuring Instruments meter read high?
If your Sotera Measuring Instruments meter reads high, it could be due to air in the system or the wrong calibration factor. To resolve this, prime the system and fix any suction leaks at the pump. Alternatively, use a higher calibration factor.
What to do if my Sotera 825 Measuring Instruments meter won't turn on?
If your Sotera Measuring Instruments meter won't turn on, the batteries may be dead, or the electronics module could be damaged or contaminated. Replace the batteries. If that doesn't work, replace the electronics module and gaskets.
What to do if my Sotera 825 meter is not consistent?
Inconsistent readings on your Sotera Measuring Instruments meter can stem from air in the system, particulates in the fluid, or a worn/damaged meter chamber. Try priming the system and fixing any suction leaks at the pump. Install a screen in front of the meter. Cleaning or replacing the chamber may also help.
What to do if my Sotera 825 is leaking fluid at inlet/ outlet port?
If your Sotera Measuring Instruments meter is leaking fluid at the inlet/outlet port, it could be due to needing thread sealant or a cross-threaded port. Add Teflon pipe tape to the joint. If the port is cross-threaded, replace the body.
What to do if Sotera 825 Measuring Instruments meter reads low by more than 10%?
If your Sotera Measuring Instruments meter reads low by more than 10%, the meter chamber may be worn, partially plugged, or damaged. You can recalibrate the meter with water, clean the chamber, or replace the chamber and recalibrate the meter.
What to do if my Sotera 825 meter Err1 is displayed?
If your Sotera Measuring Instruments meter displays 'Err1', it could be due to damaged electronics or a software fault. You can try to repair or replace the electronics. Alternatively, press 2 and then recalibrate the meter.
What to do if my Sotera Measuring Instruments meter fluid flows; meter won't count?
If fluid flows but your Sotera Measuring Instruments meter won't count, the meter disk might be sticking, or the driver/magnet may be damaged, or the meter has failed. Clean out the meter chamber. If that doesn't work, repair or replace the chamber assembly or the entire meter.
What does Err0 mean on my Sotera 825?
If your Sotera Measuring Instruments meter displays 'Err0', it indicates a calibration error or damaged chamber. Recalibrate the meter using a more accurate container. If the error persists, replace the chamber.
Why is my Sotera 825 meter display flashing or dim?
A flashing or dim display on your Sotera Measuring Instruments meter indicates low batteries. Replace the batteries to resolve this issue.
What to do if my Sotera Measuring Instruments meter reads low by 10% or less?
If your Sotera Measuring Instruments meter reads low by 10% or less, the calibration factor may be incorrect. Use a lower calibration factor.
Procedure to change the position of the meter readout.
Steps for cleaning a meter plugged with chemical or debris.
Instructions for storing the meter in a cool, dry place.
Procedure to change the meter's unit of measure to ounces, pints, quarts, gallons, or liters.
Steps to set the meter to use custom 'special' units for measurement.
Method to reset the meter's accumulated total to zero.
Procedure to check the meter's calibration and pulses per gallon.
Instructions for using FLSH mode for flushing without affecting totals.
Procedure for recalibrating the meter using clean water.
Procedure for calibrating the meter with fluids other than water using CAL factors.
Graphs to help select the correct calibration factor based on fluid viscosity.
Details on CE certification and compliance with European directives and standards.
General| Brand | Sotera |
|---|---|
| Model | 825 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
