DAB170 / English Instruction Manual
2
CHARGING THE RADIO
Before first time to operate, please fully charge the battery.
1. Open the battery cover and insert the Lithium rechargeable battery.
2. Plug the micro USB cable (included) into the socket (on the right side of the
radio). Connect the other end of the cable to power supply such as USB port of
computer or USB power adaptors for battery charging.
3. The radio will begin charging the battery. It will take approximately 2.5 hours to
fully charge the battery.
4. The charging icon will flash during charging and stop charging when the radio is
fully charged.
OPERATION YOUR RADIO
1. Make sure the battery is charged.
2. Press and hold the “POWER/MODE” button to turn on the radio.
3. The display will show “DAB+” icon and the enter DAB mode (FM mode if you
selected FM before turning off), “DAB” logo will be shown on the middle top of
the display in DAB mode whereas “FM” logo will be shown in FM mode.
4. Adjust the volume to comfortable level (Volume Level: 00-20).
5. To turn the radio off press and hold the “POWER/MODE” button. When you
turn off the radio, the mode will be memorized.
RADIO ANTENNA
1. For DAB+ and FM reception there is a built-in telescopic antenna at the top of
the unit.
2. Extend the antenna and move it around to obtain the best reception.
3. When headphone is used and plug in the headphone jack it will be acted as
antenna. The telescopic antenna will then be disabled and can be retrieved.
DAB+ MODE
1. Press the “POWER/MODE” button repeatedly until “DAB” will show in the
display.
2. Press and hold the “SCAN” Scroll Wheel button to enter the menu and select
“Scan”. The radio will scan and memorize all the channels automatically. For
first time use, the radio will automatically scan all DAB+ channels when the
power on.
3. Select channel by scrolling up and down the “SCAN” Scrolling Wheel button.
4. All the channels being scanned will be memorized until another scan is
performed.
To Next Page
Loading...
