3
Product set up
Where to put your radio
It is important that you note and follow the tips on where the radio should
be situated.
* On a flat and stable surface
* Within 1.4 metres of a power socket (if using mains power)
* Where you can fully extend the telescopic aerial
* Away from bright sunlight or heat sources, such as a radiator
* Not in a humid or very damp place such as a bathroom
Setting up
Step 1:
Connect the mains power lead into the socket on the back of the
radio (DC IN) and plug the power adaptor into the mains power wall
socket and switch on.
Step 2:
Fully extend the radio aerial in a vertical postition to obtain the
maximum signal strength.
Step 3:
Slide the power switch on the back of the radio to ON.
‘Welcome to Digital Radio’ will be displayed and your radio will
automatically scans for DAB
+
radio stations.
A progress bar will show the progress of the scan, and the number of
stations found will also
be displayed.
When the scan ends, your radio will select the first available station
and begin to play. Stations are listed in numerical and then alphabetical
order by default.
Note:
The DAB
+
radio station list is stored in the memory and the radio
will not scan for stations next time you switch it on.
Step 4:
Inserting the batteries (optional). Before installing the batteries
(not included), please ensure that the DAB
+
Radio is unplugged from the
mains power supply.
On the bottom of the radio, push in the tab on the battery cover and pull
up to remove it. Insert 4 x 1.5V LR14C-size batteries, make sure that
To Next Page
Loading...
