NR50 / English Instruction Manual
8
6. Press “Stop ” button to interrupt the recording mode anytime.
7. For encode a whole CD, please set the CD in stop mode. Then press “ ” button three
times until in the display flashes “REC USB”. The unit will start the playback and encoding
whole disc.
Remark:
- The recording speed is 1:1 and according to the actual plying time of the cd track
- The recording format is preset at bit rate: 128 kbps, sampling rate: 44.1khz
- Press “Stop ” button to interrupt the recording mode at any time.
Copying of MP3 file
If putting a MP3 disc instead of a CD-disc, the system will copy the files to the USB if press the
“ ” button. The operation procedures are the same as by CD encoding as stipulate on
above. And the system will switch to copying mode only if MP3 file being read.
DAB encoding
1. Set the unit in DAB mode and search the desired radio station which you want to encode.
2. Press the “ ” button twice until in the display will flashing the “REC USB” icon.
Encoding is now performing.
3. After finish of recoding press “Stop ” button until the symbol “REC USB” will disappear.
Aux /Phono/BT Encoding
1. Plug in the USB pen drive for recording (make sure it has enough empty space).
2. Set the unit to your desired encoding mode by pressing the function button on “PHONO”
mode or Aux or BT. Then press the “ ” button twice.
3. On the LCD display will flash the “REC USB” icon. Now the system is starting the encoding
mode.
4. Start the playback of your phono, external Aux or BT device.
5. Press the “Stop ” button to finish the recording and the symbol “REC USB” will disappear.
Track separation (On remote control only)
You can separate the recorded music from phono / radio / BT to USB stick song by song while
recording. Each time you press the “ ” button, a new title starts. This function is used for
digital title separation via analog media.
File delete at USB (by remote control)
The system is able to erase the file stored inside the USB pen drive by following:
1. Insert the media storage and set at “USB” mode.
2. Press the “delete” button and the LCD display will show (Del ---T001)
3. Press skip forward or skip backward button to select the file going to delete
4. Press the “delete” button to enter “yes/no” mode and then press skip forward or skip
backward to select “yes” or “no”.
5. Press the “delete” button again to confirm the setting.
Remark:
Press “Stop ” button once at remote control to quite delete mode.
To Next Page
Loading...
