SOUNDMASTER UR411 - Radio Tuning and Management; Automatic FM Station Scanning and Saving; Manual FM Station Tuning; Storing and Recalling FM Presets

12
- To skip to a track, press the
+
/
*
buttons.
Radio Operation
Auto Scan and Save Preset Station
1 Press the ON/OFF/SOURCE button on the unit or press the SOURCE button on the remote control
repeatedly to select FM mode.
2 Press and hold the
%)
button on the main unit or press the SCAN button on the remote control to
activate automatic programming. All available stations are programmed in the order of waveband
reception strength.
- The first programmed radio station is played automatically.
3 To select and listen to a saved radio station, press the
p
or
q
buttons to skip to the previous/next preset
radio station.
Tuning in a Station
• Tune in radio stations automatically
- Press and hold the
+
/
*
buttons, the frequency changes down or up automatically until a station is
found.
Note: The search may not stop at a station with a very weak signal.
• Tune in radio stations manually
- Press the
+
/
*
buttons repeatedly until you find the station you want.
Note: If reception is still poor, try to adjust the position of the aerial or try to move the radio to another
location.
Presetting Stations Manually
You can store up to 20 of your favourite stations to the memory. This will enable you to access your
favourite stations quickly and easily.
1 Tune in the desired station, then press the PROG button.
2 Press the
p
/
q
buttons to select the preset number.
3 Press the PROG button to store the station.
4 Repeat above steps 1 to 3 for each station you want to store in memory with a preset number.