What to do if SoundTraxx Tsunami locomotive runs but makes no sound?
If your SoundTraxx Media Converter locomotive runs but produces no sound, there might be several reasons: * The mute function (F8) could be activated. * Another function may be incorrectly re-mapped to the mute function. * The speaker wire might be broken. * The speaker itself could be burned out.
Why SoundTraxx Tsunami locomotive doesn’t run but was working?
If your SoundTraxx Media Converter locomotive suddenly stops running, consider these potential causes: * The address may have been accidentally changed. * A consist address (CV 19) might have been unintentionally set. * CV 29 could have been altered to select a different address. * Acceleration and braking CVs might be set to very high values. * There could be a broken motor wire or track pickup wire.
What to do if SoundTraxx Media Converter sound works for a while then quits?
If the sound on your SoundTraxx Media Converter works intermittently, it could be due to: * The amplifier overheating; try lowering the sound volume. * The decoder overheating; try lowering the track voltage. * A damaged speaker; consider replacing it.
General| Brand | SoundTraxx |
|---|---|
| Model | Tsunami |
| Category | Media Converter |
| Language | English |
To Next Page
