Page 22
Setpoint Limits (Setup Step 20)
Maximum Heat Setpoint (Setup Step 21) - (35 - 99 ).
Minimum Cool Setpoint (Setup Step 22) - (35 - 99 ).
Use Setpoint Limits (1) - When this level is selected, the heat and cool setpoints can
be restricted to preset levels, set in setup steps 21 and 22.
Compressor Minimum Off Minutes (Setup Step 24)
This feature allows the user to set a minimum off time for the compressor. Settings are
5 mins., 3 mins., or 0 mins.
Number of Compressor Stages (Setup Step 26)
This feature is for heat pump application only.
This feature allows the thermostat to control 1 or 2 compressor stages when configured
for heat pump.
Minimum Heat/Cool Setpoint Difference(Setup Step 25)
This feature allows the user to set the minimum gap between Heat and Cool setpoints
in AUTO mode. Select from 0 to 6. If setup step 2 is not set for AUTO-CHANGEOVER,
this step will not appear.
Cycles Per Hour (Setup Step 23)
The Cycles Per Hour setting may limit the number of times per hour
your HVAC unit may energize. For example, at a setting of 6 cycles
per hour the HVAC unit will only be allowed to energize once every 10
minutes. The Cycles Per Hour limit may be overridden and reset by
pressing the WARMER or COOLER buttons on the thermostat.
(This feature not available on all models)
Installer Setup
This feature allows the user to set 4 different levels of security: (0 - 3).
No Setpoint Limits (0) - When this level is selected, no restrictions are activated.
Force Program Mode (2) - When this level is selected, the heat and cool setpoints can
be restricted to preset levels, set in setup steps 21 and 22 and the thermostat is locked
into the current mode and time period program setting.
S
e
tpo
i
n
t
s
Fr
o
z
e
n
(
3
)
-
W
h
e
n
t
h
i
s
le
v
e
l
is
s
e
l
e
c
t
e
d
,
t
h
e
h
e
a
t
a
n
d
c
o
o
l
se
t
p
o
i
n
t
s
,
t
h
e
c
u
rre
n
t
mo
d
e
, a
n
d
t
i
m
e
p
e
r
io
d
p
ro
g
r
a
m
s
e
tt
i
n
g
s
a
r
e
lo
cke
d
.
To Next Page
Loading...
Need help?
General
