Selecting Your Time Period Schedule (setup step 1)
This thermostat may be configured to be programmable or non programmable.
7 Day Program - Allows all seven days to be programmed independently.
Non Program - No advanced time period programming available.
1 Day Program - Allows one 24 hour day to be programmed. This same
schedule will be repeated every day the program is set to run.
5/1/1 Day Program - Allows weekdays, Saturday, and Sunday to be
programmed independently.
Selecting Your Available Modes (setup step 2)
Auto-Changeover - Allows the thermostat to turn on heating or cooling based
on room temperature demand. Also allows the manual selection of HEAT only
or COOL only and OFF.
Heat and Cool - Allows the thermostat to turn on heating or cooling depending
on which one has been manually selected. Auto-Changeover is not available
when this mode is selected.
Heat Only - Allows the thermostat to only turn on HEAT or OFF modes.
Cool Only - Allows the thermostat to only turn on COOL or OFF modes.
Programming a Daily Time Period Schedule*
*not available when Wi-Fi module is present
To enable (RUN) or turn ON the Time Period Schedule press the Program
button momentarily.
To turn Off the Time Period Schedule stored program press this button again.
To alter the Time Period Schedule settings; press & hold this button for 5
seconds until the “Set Program” prompt appears. Modify the settings with
the Warmer and Cooler buttons. Use the Mode button to advance through the
steps. Press the Program button again to leave the setup screens.
Program Button
(continued next page)
24
User Setup - Time Period Programming
ADJUST
NEXT
PROG | RUN | SET
MODE
To Next Page
Loading...
Need help?
General
