SA249 C4 Synth User Guide 10
Power and Control Connections
DC 9V (Power)
Connect to the included 9 Volt DC power supply. The power supply must be regulated at 9 Volts
(direct current), able to source at least 165 mA (milliamps) of current, and the plug should have a tip-
negative, sleeve-positive polarity (the center tip is ground and the sleeve is power).
USB
Connect your computer (Mac or Windows) to the C4’s USB port (denoted by the icon) using a
standard mini USB cable. The USB port handles communication between the pedal and the Neuro
Desktop Editor or a digital audio workstation (DAW). The C4 will also respond to MIDI messages from
an external MIDI Controller with USB host support. The C4 is a class compliant USB device, meaning
that Mac and Windows computers will recognize it automatically. For more information about the
C4’s USB capabilities, refer to the USB section of the User’s Guide.
CONTROL INPUT Port
The 3.5 mm CONTROL INPUT Port connects to external control devices such as the Source Audio
External Tap Switch, Dual Expression Pedal, Neuro Hub, and Hot Hand 3 Motion Controller. For more
information, refer to the External Control and Neuro Hub sections of the User Guide.
ALT (Alternate) Button
The small black button located on the topside of the pedal, next to the CONTROL INPUT jack.
Pressing the ALT button temporarily puts the pedal into Alternate Control Mode (indicated by the
blinking top center LED). Alternate Control Mode switches from the Primary to Secondary function of
the INPUT/SENS and MIX/VOL knobs. Also moving the center toggle switch will switch between the
Green and Red Preset Banks (go to the Preset Banks section for more info).
To Next Page
Loading...
