Terminating Category-Style Twisted Pair Cable
Cut
Strip
Prep - RJ45 Data Jack
A. Cut cable to length.
B. Use an appropriate stripping tool to remove
1.5” (38mm) of outer jacket from the end of the
cable. Inspect conductors to make sure there are
no nicks in the insulation.
C. Untwist the conductors.
Lace the conductors into the corresponding color
coded slots. The jack will have color-code guides
for T568A and B wiring schemes.
All the cables in the facility should be wired
to the same scheme to prevent network errors.
Minimize the amount of wire untwisted between
the cable jacket and the termination slots.
D. Untwist and straighten the conductors.
Arrange the conductors into the proper sequence as
shown below (either 568A or B).
Cut the wires approximately ½” (13mm) from the end
of the jacket. Orient the plug as shown.
Insert the wires into the plug checking that they go all
the way into the correct pin slots.
RJCC-T1
XSR-T1
Test
M300P
PDTP-K1
Prep - RJ45 Plug
1
2
3
4
5
6
7
8
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
1
2
3
4
5
6
7
8
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown
T568B
T568A
Pin 1
RJ45 Plug
Terminate
RJCC-T1
Product distributed by Southwire Company, LLC
One Southwire Drive, Carrollton, GA 30119
©2014 Southwire Company, LLC. All rights reserved.
southwiretools.com
1-855-SW-T00LS
Toll Free Technical Help
Línea de Ayuda Técnica Gratuita
3/15 Rev. 0
UTPInstruct manual
To Next Page
Need help?
General
