• Only qualified persons should operate the Maxis
®
XD1 Extreme
Duty Circuit Puller.
• Wear eye protection, hard hat, cut resistant gloves and safety
toe shoes when using this tool.
• Do not use tool when tired or under the influence of drugs,
alcohol, or medication.
• Keep body parts and loose clothing away from moving parts.
• Always follow operating procedures.
• Avoid accidental starting. Make sure switch is off before
plugging in motor.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT
IN SEVERE INJURY OR DEATH.
WARNING:
Personal Safety Hazards
WARNING
• Read and understand all instructions and safety information in
this manual before operating or servicing this tool.
• Read the instruction manual supplied with your drill before
operating the Maxis
®
XD1 puller.
• Failure to observe these warnings could result in severe injury
or death.
3
IMPORTANT SAFETY INFORMATION
4
IMPORTANT SAFETY INFORMATION
DANGER : Electrical Shock Hazards
• Do not use this tool near live circuits. Shut off and lock out power
when working near existing circuits.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT
IN SEVERE INJURY OR DEATH.
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
WARNING
: Entanglement Hazard
• Do not operate this tool while wearing loose-fitting clothing.
Retain long hair.
• Keep hands away from the puller’s capstan. Rope at the capstan
can crush a hand.
• Stop hand drill when wrapping rope on capstan.
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
WARNING
: Tool Use Hazards
• Use this tool for manufacture’s intended purpose only. Use other
than that which is described in this manual can result in injury or
property damage.
• Inspect all aspects of the pull to ensure safety.
• Only qualified personnel should use pulling equipment.
• Do not use the cable puller as hoist or winch. The cable puller
cannot lower a load. The load may fall and cause serious injury
or death.
To Next Page
Loading...
