What to do if my Southwire Construction Equipment bender has power but won't operate?
If your Southwire Construction Equipment bender has power but isn't operating, there are a few things you can check: * Ensure the power switch is in the "ON" position and lit green. * Inspect the 15 amp fuse. * Check for power at the motor. If the switch is on and the fuse is good, the motor might be bad.
Why is my Southwire Construction Equipment motor running but the bender will not bend?
If the motor is running but the Southwire Construction Equipment bender isn't bending, consider these potential causes: * A broken chain from the transfer shaft. Remove the cover and visually check for broken parts. * A bad gear box. This is indicated by the motor running but no output through the gear box. * A broken chain from the jack shaft to the shoe sprocket. Remove the cover and visually inspect for broken components. * A missing key between the motor and gearbox. Remove the motor from the gearbox to check.
Why does my Southwire Construction Equipment bender only operate in one direction?
If your Southwire Construction Equipment bender only operates in one direction, the issue might stem from: * A faulty Bend/Return switch. Use an ohmmeter to check the switch for open or shorted contacts. * A bad pendant cord. Use an ohmmeter to check for a broken wire.
General| Brand | Southwire |
|---|---|
| Model | BENDMAX |
| Category | Construction Equipment |
| Language | English |
To Next Page
