109
SETUP AND OPERATION SETUP AND OPERATION
C. When pulling from the side, make a loop in the end of the
polyline/ mule tape and attach the eye around the Polyline/Mule
Tape Pin (10) on the Capstan (1) (Fig 7). This will allow the
polyline/mule tape to continuously accumulate onto the
Capstan (1) (Fig 8). Switch the 18-Volt drill into REVERSE
and engage drill motor.
Fig 7 Fig 8
ROPE PULL SETUP
A. When pulling underground or from below, wrap rope over
the top of Capstan (1) in a clockwise direction multiple times
(Fig 9) and switch the 18-Volt drill into REVERSE and payoff like
most conventional wire pullers.
Fig 9
B. When pulling overhead or from above, pull forward pin on
Front Extension (6) and rotate 180 degrees and insert back into
Base Arm (5) and reinstall pin (Fig 5 and 6). Wrap rope under
the bottom of the Capstan (1) and wrap rope counter-clock-
wise. Ensure 18-Volt drill is in FORWARD and payoff like most
conventional wire pullers.
Fig 5 Fig 6
C. When pulling from the side, wrap rope around Capstan (1)
across the top of the Capstan (1) wrap the rope in a clockwise
direction multiple times and switch the 18-Volt drill into
REVERSE and payoff like most conventional wire pullers.
To Next Page
Loading...
