19
Plug replacement
If you need to replace the tted plug, then follow the
instructions below. IMPORTANT: The wires in the mains lead
are coloured in accordance with the following code:
Blue – Neutral
Brown – Live
As the colours of the wire in the mains lead of this apparatus
may not correspond with the coloured marking identifying the
terminals in your plug, proceed as follows. The wire, which is
coloured blue, must be connected to the terminal, which is
marked with N or coloured black. The wire, which is coloured
brown, must be connected to the terminal, which is marked L
or coloured red.
WARNING: Never connect live or neutral wires to the earth
terminal of the plug.
Only t an approved 13 Amp BS 1363 or BS 1363/A plug and
the correctly rated fuse.
If in doubt, consult a qualied electrician.
NOTE: If a moulded plug is tted and has to be removed take
great care in disposing of the plug and severed cable; it must
be destroyed to prevent engaging into a socket.
13 AMP fuse
approved to
BS 1362
Connect Blue
to N(Neutral)
Brown L(Live)
Outer sleeve
firmly clamped
Cable grip
To Next Page
