SP VirTis BenchTop 2K - Available Configurations; From Freeze Dryer to Condenser Module; Cold Trap Condenser Module

To Next Page

To Previous Page

Introduction VirTis BenchTop 2K, 4K and 6K

2 Revision 004, 12/09

Available Configurations

Freeze-drying in

the condenser

Shelf unit in

drum manifold

Vertical manifold

Flask drying on

drum manifold

Flask drying on drum

manifold with stoppered

Fitted for cold

trap application

shelves

From Freeze Dryer to Condenser Module

When using your BenchTop as a condenser module, the vacuum cover plate is

replaced with either a ¾-inch stainless steel port for the manifold plate or a plain cover

plate, which must be purchased separately if no manifold is ordered. The manifold

adapter plate is required when any manifold is purchased.

Cold Trap Condenser Module

When using a vacuum concentrator or gel dryer with your BenchTop unit, the

condenser module can be used as a cold trap, which traps vapors driven off of the

product before they reach the vacuum pump. For more information, refer to Chapter 6:

Cold Trap Condenser.

Note: A low temperature condenser is required when trying to trap organic solvents.