Spa-Quip SP601-15 User Manual

AUTO
PUMP
HEATER
AIR
ON
<TEMP SET>
HOLD BUTTON
TO ADJUST
PRESS BOTH
TO READ ACTUAL
HEATHEATHEATHEAT PUMP AUTO AUTO AIR PUMP AUTO AUTO AIR
ONON
User’s GuideUser’s Guide
Models Covered ByThis User’s Guide :
SP601-15
SP601-15T
SP601AU-15
SP601AU-15T
SP601-20
SP601-20T
SP601AU-20
SP601AU-20T
SP601-30
SP601-30T
SP601AU-30
SP601AU-30T
SP400P
SP400PAU-10
SP400PAU-15

Spa-Quip SP601-15 Specifications

General

Brand	Spa-Quip
Model	SP601-15
Category	Controller
Language	English

Summary

Touch Pad Interface and Indicators

Auto and H20 LED Indicators

Pump and Heat LED Indicators

Temperature Control Features

Adjusting Set Temperature

How to adjust the spa's set temperature using up/down buttons.

Heating Mode Selection

Pump 1 Operation (Single Speed)

Single Speed, No 24hr Circulation

Single Speed, With 24hr Circulation

Pump 1 Operation (Two Speed)

Two Speed, No 24hr Circulation

Two Speed, With 24hr Circulation

Auto Sanitisation and Filtration

Filtration without 24hr Pump

Automatic filtration maintenance for spas without 24hr circulation.

Adjusting Minimum Filtration Time

Filtration with 24hr Pump

Self-Diagnostic Error Codes

Error 1 (H20) - Prime Failed

Indicates no water detected in the heater housing.

Error 3 - Stuck Button

Error due to a stuck touchpad button.

Error 4 - No Water Sensor

Problem with the optical water sensor in the heater.

Error 5 - Overtemperature

Heater or pool temperature detected at 45°C or more.

Error 6 - Thermal Cut Out Tripped

Safety electromechanical over-temperature cut out on the heater operated.

Error 7 - Stuck Relay

Problem with the heater control circuitry.

Error 8 - No Temperature Data

Problem with the digital temperature sensor or data connection.