Form 43471000
-6- May 2021
CONTROL/DRAFT INDUCER PACKAGE NUMBERS
B. Body Package Descriptions
6.1) ACCESSORY PACKAGES
A. Exhaust Hood Package, Part #42924000
Contains:
Exhaust Hood Assembly, #42925550……QTY–1
#8-18 x ½ Self-Drilling Screws, #02189030……QTY–2
B. Lower Mounting Kit, Part #43515000
The Lower Mounting Kit is required when the heater
is installed at mounting heights between 6 ft. and 8
ft. above a finished floor.
Contains:
Emitter Guard Kit, #43485000……QTY–1
(The Emitter Guard Kit includes an aluminum
decorative grille with side emitter guard holder panels.
This item and the Draft Inducer Guard Kit make up the
Lower Mounting Kit, which must be used in
installations with mounting heights between 6 ft. and
8 ft. This item could be used separately in
installations above 8 ft., however, for decorative
purposes if desired.)
#43468000, 8Ft. Body Package ........................................................................................................... 1
Containing: #43469000, Pre-assembled 8’ ALC steel tube assembly with reflectors .......... 1
#42762010, Control End Reflector ........................................................................... 1
#42761010, Foot End Reflector ................................................................................ 1
#02125130, #10-24x1/2 Screws .............................................................................. 4
#02189020, #10-16x1/2 Screws .............................................................................. 2
#02266010, Speed Clips ........................................................................................... 14
#42769010, Sliding Clamps ...................................................................................... 4
To Next Page
Loading...
