SpaceraiL LEVEL 1 - Coaster Assembly and Preparation; Prepare Coaster Components

Spacerails, LLC. All rights reserved. Spacerails.com Page 3
1
PREPARE THE COASTER COMPONENTS
Prepare the Loop: Press one
Rail Clip to both sides of the Loop
Assembly. Attach the Loop Stand
to the bottom of the Loop.
Prepare the Turns: Press one
Rail Clip to both sides of all six
Corner pieces.
B LOOP & TURNS
NOTE:
Corners are identied on the
bottom of each piece.
C
RAIL SPLITTER
Prepare Rail Splitter: Attach one Rail
Clip to each of the Rail-Splitter posts.
Step 1: Attach one Arm Holder A and one
Arm Holder B with one Arm Sheath. Insert
one Arm Clip into Arm Holder A.
Step 3: Turn the Arm Lock
counter-clockwise to secure
the Arm Clip in place.
Step 2: Insert Arm Lock through
Arm Holder A and Arm Clip.
A
ARMS QTY: 5
To avoid damaging parts, do not move or adjust the Rail Clip while locked in the arm. To move the Rail Clip, release
Arm Lock by turning clockwise, position Rail Clip as desired, then secure Arm Lock again.