Page 12 Seaich Corporation, LLC. All rights reserved. www.seaich.com
|
Spacerails, LLC. www.spacerails.com
Step 1: Lay out rail on a at surface. Measure each section and mark the cutting point with a pen.
Step 2: Cut each of the 8 rail sections according to the measurement shown below. Make sure to cut at a 90° angle.
All of these rail dimensions include extra rail. They will all need to be cut shorter based on their
nal placement and positioning. It is easier to position with more rail than you need and then
cut a long rail shorter. Illustration of rail lengths is not to scale. Please see the included tri-fold
with printed ruler for laying the rail out on a template to measure.
CUT THE RAILS TO SIZE
G
NOTE:
R-A
150 cm
270 cm
R-B
210 cm
R-C
150 cm
R-D
To Next Page
Loading...
