Page 14 Seaich Corporation, LLC. All rights reserved. www.seaich.com
|
Spacerails, LLC. www.spacerails.com
Elevator entry: Make sure the rails enter the elevator
straight and aren’t too long, or angled, or the Marble will
hit the elevator shaft and bounce out.
Elevator entry angle: Make sure the rails are not overly
angled upon entry to the elevator. You may need to
place a Rail Clip before the entry to straighten.
Broken Arm Clip: If you end up accidentally breaking
an arm clip, replace it with a spare. If your have no more
spares, place a Rail Clip before or after it at the same
angle as the Arm Clip.
Elevator exit: When installing the elevator exit rails,
pull the rails close to the Elevator Helix to ensure the
Marble enters the roller coaster smoothly.
Corner shape: To help the Marble maintain speed, shape
corner rails like the above, not like a straight section. You
may need to use Rail Clips to create the curve.
Slow before corners: Reduce Marble speed before taking a
corner by lowering the rail track via the arm.
To Next Page
Loading...
