Your system may be equipped with optional overhead lights.
Use of these lights usually requires no effort on your part. The
lights will come on when the aisle is opened or when an aisle is
entered. The lights will shut off automatically shortly after you
leave the aisle.
If the lights do not turn on when an open aisle is entered, simply
press the “Move” button on the controls on either side of the
aisle.
If the lights are not timed to turn off automatically after leaving
the aisle, they can be turned off by pressing the “Stop/Reset”
button on the controls on either side of the aisle.
Lighting Options
CONTROL INDICATION
Abnormal Carriage Movement
Controls on both sides of the
open aisle display “Aisle in Use”
and the LED is flashing red
None of the controls work;
None of the LED’s are lit
All or most controls display a
blinking red LED
SOLUTION
• Check rails for debris; clean
rails
• Check the aisle for people or
materials obstructing safeties
• Press the “Stop/Reset” button
• If there is no apparent
obstruction, check the LED
on one end of the Photo
Sweep. If the LED is not
flashing green, call for
service.
(The safety override
key may be used in the
interim – see the Safety
section of this manual)
• Is the system locked (via
remote, key, etc.)?
• Is power supplied to the
system? In the event of a
power outage, use your
power outage option (if
purchased).
• Call Service
• Call Service
Troubleshooting
12
To Next Page
Loading...
Need help?
General