6
ENGLISH
Battery-Connector
The battery-connector will be unplugged before
the transport to avoid any damage on the battery.
Simply grab both ends of the 2 cables and stick
them together via the direction printed on
both connector-ends.
1
Check all screws
Before starting the scooter make sure that all
screws are tightened. Especially the screws for
the accelerator + the brake can loosen up a bit
during the transport. All screws can be checked
with a conventional screwdriver + hexagon.
2
UNFOLDING STEPSFIRST STEP
Release the folding lever
Lift the steering pipe slightly and press the
folding button at the same time. The direction
is indicated on the above picture.
Raise the steering pipe until the location
pin reaches the location shown on the above
picture.
Push the handlebar in the direction of the
arrows. The folding lock locks automatically
when reaching the 90º angle.
After assembling the handlebars, make sure
that the folding locks on both sides are fully
inserted.
1
Unfolde the handlebars
2
A
B
A
B
To Next Page
Loading...