SR100 REMOTE CONTROL CAR ALARM SYSTEM
17
TROUBLE SHOOTING GUIDE
REMOTE CONTROL TRANSMITTER
Pressing button on remote control does not light LED
Discharged or missing battery. Replace battery.
Poor connection. Adjust terminal to ensure good battery contact.
BATTERY REPLACEMENT
The battery needs replacing if the transmitter indicator LED does not light when the
transmitter button is pressed.
To replace the battery remove the screw from the near of the casing and carefully
separate the transmitter moulding.
Replace with 12 volt Sparkrite battery Part No. SR904 observing correct polarity.
ARMING AND DISARMING
Pressing button on remote control lights the transmitter indicator LED but alarm does
not arm/disarm.
No power supply to unit. Check wiring, fuse and using a suitable
tester,
Check that 12V is present on the RED wire.
Check the BLACK wire is securely
connected to a good earth.
Distance between transmitter Move closer and try again.
and receiver is too great.
NOTE: The operating range can vary due to changes in atmospheric conditions.
CURRENT SENSING
Check position of s election switch.
Interior light failed. Check bulbs.
Current sensing not working Increase trigger sensitivity by
when interior light illuminated relocating RED wire to an alternative
12V supply further from the battery in
the fuse box.
To Next Page
Loading...