ENGLISH 13
Unit installation
Install the compressor on a level surface in a well-ventilated room with adequate space.
Room temperature should not exceed 35°C.
2. Connect the supplied spiral coiled tube up to the compressor.
3. Affix the supplied airbrush holder on the table.
4.+ 5. Unscrew the fastening nut from the pressure regulator.
6. Insert the pressure regulator through the mount on the airbrush holder from below
and screw the fastening nut back on from above.
7. Now connect the other end of the spiral coiled tube up to the pressure regulator.
IN side
8. Connect the supplied tube up to the air outlet on the pressure regulator.
9. Connect the other end up to your airbrush device.
1 2
3
7 8
9
4 5
6
To Next Page
