EasyManua.ls Logo

Sparmax TC-2000 - User Manual

Sparmax TC-2000
32 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Bedienungsanweisung 2-9
Operating Instructions 10-16
Gebruiksanwijzing 17-23
Bruksanwisning 24-30
Sparmax TC-2000
Question and Answer IconNeed help?

Do you have a question about the Sparmax TC-2000 and is the answer not in the manual?

Summary

Introduction

Preface

This operating manual applies to type TC-2000 series compressors.

Important safety instructions

Please read the operating manual carefully prior to commissioning and observe the instructions contained therein!

Environmental protection instructions

Warning instructions

Warning and Note Symbols

Explains symbols for hazards, user tips, environmental notes, and numbered instructions.

Warranty

Initial Commissioning Checks

Includes unpacking, checking for damage, voltage verification, and unit integrity.

Unit installation

Installation Steps

Connects the spiral tube, airbrush holder, and pressure regulator for compressor setup.

Beginning of operation

Setting the working pressure

Set the desired working pressure using the pressure regulator knob.

Thermal protector

Deactivating the compressor

Turn the on/off switch to the 'OFF' position to deactivate the unit.

Maintenance work

Draining water from the moisture trap

Drain condensate water from the moisture trap daily after use.

Technical data

Fault table TC-2000

Summary

Introduction

Preface

This operating manual applies to type TC-2000 series compressors.

Important safety instructions

Please read the operating manual carefully prior to commissioning and observe the instructions contained therein!

Environmental protection instructions

Warning instructions

Warning and Note Symbols

Explains symbols for hazards, user tips, environmental notes, and numbered instructions.

Warranty

Initial Commissioning Checks

Includes unpacking, checking for damage, voltage verification, and unit integrity.

Unit installation

Installation Steps

Connects the spiral tube, airbrush holder, and pressure regulator for compressor setup.

Beginning of operation

Setting the working pressure

Set the desired working pressure using the pressure regulator knob.

Thermal protector

Deactivating the compressor

Turn the on/off switch to the 'OFF' position to deactivate the unit.

Maintenance work

Draining water from the moisture trap

Drain condensate water from the moisture trap daily after use.

Technical data

Fault table TC-2000

Sparmax TC-2000 Specifications

General IconGeneral
Auto StopYes
Thermal Overload ProtectorYes
TypePiston
Air Tank2 liters
Voltage220-240V / 50Hz
PressureAdjustable

Related product manuals