22
Start-Up Guide
GENERAL MAINTENANCE
Rod Guide
The rod guide is an integral part of the coiler which will increase the longevity of the push rod if maintained correctly. By allowing the
guide material to wear out first, it significantly decreases wear to the push rod jacket. Please clean all parts thoroughly with clean water
if dirt builds up.
Connector and Cable Care
Connectors and cables are an integral part of any system. Taking good care of these will allow the electrical signals to reliably transmit. It
is therefore essential to check the cable, connectors and interfaces after each inspection.
• Ensure the system is disconnected from the power supply.
• Check connector pins are all intact, clean, and no visible damage is present on the cable.
• Check O-rings for damage and replace if necessary (grease regularly).
• If damage is located, contact Spartan Tool, LLC or its authorized agents.
NOTE: Depending on the camera system and year of manufacture, a variety of different cables and connectors will
have been used, but the principle of care remains the same.
CLEANING AND MAINTENANCE
To increase the service life of your TrapJumper equipment, we recommend the devices and components are kept clean and serviced. To
achieve the greatest improvement in longevity, pay close attention to moving parts like rollers. Spartan Tool, LLC also notes a significant
reduction in the danger of catching infections from the equipment if cleaned thoroughly after each use.
The following list provides a guide on some care and maintenance measures that should be applied when operating TrapJumper
equipment. This will not replace repairs and maintenance entirely but should prolong the life of the equipment and reduce time spent
with Spartan Tool, LLC Service Department or its authorized agents.
• Always be vigilant and clean/replace parts after every inspection according to their condition.
• Check for loose parts after every inspection.
• Clean camera heads with water after use and remove all debris (a soft brush may be required).
• Ensure the connector contacts are clean, use an electrical contact cleaner, if cleaning is required.
• Use clean water only. Don't add any cleaning products.
• If the Explorer control keypad/screen has been used in the rain, dry with a clean cloth and leave open until all water has
evaporated.
• Keep all power leads, chargers and accessories clean and dry.
• Clean all parts that have had contact with the inspection area thoroughly and wipe them over with a cloth if necessary after
every use.
• Roll cables up neatly after use and store in a dry area.
WARNING: Never use a high pressure cleaner or any cleaning agents on any of the Explorer equipment. It may result
in damaging components, O-ring and increase the need for repair.
NOTE: It is the sole responsibility of the user to keep the equipment to a good standard, any repairs required due to
negligence will invalidate the warranty and will be chargeable.
To Next Page
Loading...