Speakman SA-1004 - User Manual

Instructions for Models:
SA-1004
SA-1005
SA-1006
SA-1007
Need Help?
For additional assistance or service call:
SPEAKMAN Company
400 Anchor Mill Road
New Castle, DE 19720
PHONE: 800-537-2107
EMAIL: customerservice@speakmancompany.com
WEB: www.speakmancompany.com
92-SA-100X-R2
What You Need To Know:
Tools:
Required:
*Phillips Screwdriver *Small Flat Tip
Screwdriver
*Drill with 1/4” bit *Pencil
Helpful:
*Tape Measure *Level
Important Notes:
Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur.
Instruction images shown are for reference only
and apply to all models numbers shown.
Safety Tips:
This item is NOT designed for use as a grab bar.
Do not mount in locations where product is likely
to be used as a grab bar.
Maintenance:
Clean with a soft, damp cloth only. Do not use
scrub pads, detergents or cleansers as they may
harm the protective finish of your bath accessories.
�
�
�
�
�
Loosen set screw at base of each post and
remove brackets (if necessary). Determine
mounting location of component and lightly
trace outline on wall with a pencil.
Center Mounting Bracket within traced outline.
Mark the 2 mounting locations with a pencil.
Drill 1/4” holes in marked locations. If mounting
directly into stud or wood wall, secure Mounting
Bracket to wall using Mounting Screws without
drilling holes.
Insert Plastic Anchors into drilled holes and press
in until flush with wall. Secure Mounting Brackets
to wall with Mounting Screws using Phillips
Screwdriver.
Locate post over Mounting Bracket and tighten
Set Screw with Small Flat Tip Screwdriver.
Repeat steps 1 thru 5 for remaining items.
Mounting
Bracket

Summary

Instructions for Models

What You Need To Know

Tools Required

Lists necessary tools for installation.

Helpful Tools

Lists optional tools that can assist installation.

Important Notes

Provides crucial advice before and during installation.

Safety Tips

Advises against using the product as a grab bar.

Maintenance

Details cleaning instructions to preserve the product finish.

Installation Steps

Prepare Mounting Location

Loosen set screws, remove brackets, and trace outline on wall.

Drill Holes and Insert Anchors

Drill 1/4" holes or secure directly into studs, then insert anchors.

Mount Product Post

Center bracket, mark locations, and tighten set screw to secure post.

Model Components and Dimensions

Towel Bar Components

Illustrates parts and dimensions for 18" and 24" towel bars.

Towel Ring Components

Illustrates parts and dimensions for the towel ring.

Robe Hook Components

Illustrates parts and dimensions for the robe hook.

Tissue Holder Components

Illustrates parts and dimensions for the tissue holder.

Need Help?

Speakman SA-1004 Specifications

General

Brand	Speakman
Model	SA-1004
Category	Bathroom Fixtures
Language	English