SPEC-D Tuning 2LHP-DEN07-TM - Step 5: Pull Out Headlight Assembly; Step 6: Disconnect Headlight Connectors; Step 7: Remove Harness from OEM Headlight; Step 8: Remove Driving Light Bulb

5. Pull out the headlight a little bit, just enough to see the
wire harness in the back
9. Connect the driving light socket to the LED wire
please make sure that the black wire (negative) and
connects with the black wire
6. Disconnect the connectors from the headlight
7. Remove the harness from the OEM headlight
Please see the “Halo and L.E.D installation instructions”
8. Pull out the driving light bulb
10. Connect all the connectors and harness to new headlight
If your headlights don’t have HALO or L.E.D. You can skip
W W W . S P E C D T U N I N G . C O M
If your headlights don’t have HALO or L.E.D. You can skip
p2