33
lubricant with a lint-free cloth. Lubrication is a function of climate. Talk to
your dealer about the best lubricants and the recommended lubrication
frequency for your area. Avoid contaminating the rims with lubricant!
4. After every long or hard ride or after every 10 to 20 hours of riding:
• Squeeze the front brake and rock the bike forward and back. Everything feel
solid? If you feel a clunk with each forward or backward movement of the bike,
you probably have a loose headset. Have your dealer check it.
• Lift the front wheel off the ground and swing it from side to side. Feel
smooth? If you feel any binding or roughness in the steering, you may have a
tight headset. Have your dealer check it.
• Grab one pedal and rock it toward and away from the centerline of the bike;
then do the same with the other pedal. Anything feel loose? If so, have your
dealer check it.
• Take a look at the brake pads. Starting to look worn or not hitting the wheel
rim squarely? Time to have the dealer adjust or replace them.
• Carefully check the control cables and cable housings. Any rust? Kinks?
Fraying? If so, have your dealer replace them.
• Squeeze each adjoining pair of spokes on either side of each wheel
between your thumb and index nger. Do they all feel about the same? If any feel
loose, have your dealer check the wheel for tension and trueness.
• Check the tires for excess wear, cuts or bruises. Have your dealer replace
them if necessary.
• check the wheel rims for excess wear, dings, dents and scratches. Consult
your dealer if you see any rim damage.
• Check to make sure that all parts and accessories are still secure, and
tighten any which are not.
• Check the frame, particularly in the area around all tube joints; the
handlebars; the stem; and the seatpost for any deep scratches, cracks or
discoloration. These are signs of stress-caused fatigue and indicate that a part is
at the end of its useful life and needs to be replaced. See also Appendix B.
WARNING: Like any mechanical device, a bicycle and its components
are subject to wear and stress. Different materials and mechanisms
wear or fatigue from stress at different rates and have different life
cycles. If a component’s life cycle is exceeded, the component can
suddenly and catastrophically fail, causing serious injury or death to the
rider. Scratches, cracks, fraying and discoloration are signs of stress-
caused fatigue and indicate that a part is at the end of its useful life and
needs to be replaced. While the materials and workmanship of your bicycle
period of time by the manufacturer, this is no guarantee that the product
will last the term of the warranty. Product life is often related to the kind of
riding you do and to the treatment to which you submit the bicycle. The
bicycle’s warranty is not meant to suggest that the bicycle cannot be
broken or will last forever. It only means that the bicycle is covered subject
to the terms of the warranty. Please be sure to read Appendix A, Intended
Use of your bicycle and Appendix B, The lifespan of your bike and its
components, starting on page 35.
5. As required: If either brake lever fails the Mechanical Safety Check (Section
To Next Page
Loading...
