10
FRAME WIRING LENGTHS
LOCATION QTY LENGTH
JCT B Box to Cockpit (Shifter) 1 1400 mm
JCT B Box to Rear Derailleur 1 750 mm
JCT B Box to Front Derailleur 1 500 mm
JCT A Box to Battery (Seatpost) 1 1000 mm
(Shimano Di2)
Route a 1400 mm wire from the head tube ICR port, down the down tube
and out the bottom bracket hole.
The Di2 wire must be routed into the down tube before the rear
brake housing.
Route a 750 mm wire starting from the chainstay port and out the
bottom bracket hole.
Route a 500 mm wire starting from the seat tube front derailleur port
and out the bottom bracket hole.
Route a 1000 mm wire down from the top of the seat tube and out the
bottom bracket hole.
Install the battery sleeve on the battery, then install the battery/sleeve
assembly in the seatpost.
Plug the 1000 mm battery wire into the battery, then install the seatpost
as described in section 7.
Plug the four wires exiting the bottom bracket shell into a Junction B
box, then place the Junction B box and the wires in front of the bottom
bracket shell.
To prevent the JCT B box from rattling, wrap the box in a bit of
foam before placing it in front of the bottom bracket shell.
To Next Page
Loading...
