Table of Contents
4.2.3 Ending evaporation...............................................................................12
4.3 Evaporation from crucibles......................................................12
4.3.1 Crucible lids............................................................................................12
4.4 Operation with the Flux Controller.........................................13
4.4.1 Setting up Manual Control of the PID Controller................................14
4.4.2 Setting the Maximum and Minimum Output......................................15
4.4.3 Setting up Auto Control........................................................................16
4.4.4 PID and Controller Parameters..............................................................17
4.4.5 Safe operation tips................................................................................17
5 Maintenance 19
5.1 Replacing the filament.............................................................19
5.2 Making a new filament............................................................20
6 Specifications and Options 21
6.1 Physical......................................................................................21
6.2 Beam..........................................................................................21
6.3 Power Supply............................................................................22
6.4 Options......................................................................................22
7 Drawings 23
EBE-1