“ ”: Double cup of coffee switch,touch it to start extracting coffee
after preheated , the indicator lamp " " breath flashes. Automatically
extract until the machine stops working or touch the button again to stop
working during the extraction process， the indicator lamp “ ”、“ ”
and“ ” become constant light. (The automatic extraction time
machine has been set and contains pre-brewed coffee time)
" " : steam preheating switch, touch the switch, the indicator lamp "
" flashes ，begin to preheat the steam. After the preheated, the indicator lamp
" " become constant light and the machine enters the steam making mode.
(If you touch the steam preheating switch again during the whole process, the
machine switches back to the coffee extraction state from steam preheating. If
the indicator lamp“ ” 、 “ ”flashing , It indicates that the coffee
temperature is too high, you need to cool naturally or make hot water manually.
Coffee cannot be extracted until the indicator lamp “ ”、“ ”and“ ”
become constant light.)
The steam knob: The steam knob shown below is in the closed position.
There are two working states when the steam knob is turned on. When the
machine is in coffee mode, the steam pipe gives hot water. When the
machine is in steam mode, the steam tube gives steam .
Note: when the power is turned on, the steam preheating indicator keeps
flashing fast, it means that the steam knob is not closed, and you can
turn the steam knob to the closed position .
A. BEFORE THE FIRST USE（Important）
1.Move the coffee maker from the package, and check the accessories
according to the list；
2. Clean all the detachable components；
3. Remove the red silicone from the water tank before using the coffee maker ;
4. Pour water into water tank and the water level should not exceed the "max"
mark， Put back the water tank and close the water cover;
5. Plug in and press the ON/OFF switch“ ”. At this time, all indicator lamps
are flashing，The machine starts to preheat, when the indicator lights stop
blinking and turns normal on, the preheat is completed, it takes about 1 minutes.
6. After the preheating is completed, turn the steam knob counterclockwise to
the maximum position, and the electromagnetic pump works until continuous hot
water comes out from the steam pipe and at least 30 seconds (this process
takes 1-2 minutes) to clean the steam pipe, then turn off the steam switch;
7. From position " " to position " " , rotate counterclockwise to install the
filter holder（No coffee powder added） into the funnel holder of the machine,
To Next Page
Loading...