Spector COFF1001 - Making Hot Water

3. Touch steam switch“ ”, it starts preheating, Single-cup and Double -cup
coffee indicator go out, steam indicator is flashing, then wait for steam
indicator lights on, now preheating finished.
4. Put an empty cup under the steam pipe, turn the "steam knob"
counterclockwise to the maximum position, release a little water in the steam
pipe, and turn the "steam knob" clockwise to turn off the steam after the
steam comes out.
5. Put a stainless steel cup under steam nozzle，Let the steam pipe nozzle float
below the surface of the milk;
6. Open steam knob, rotate it to the maximum position to frothing milk；
7. When desired milk foam reached, then turn off knob, steam is stopped,
remove cup and pour the frothed milk into prepared espresso, now
cappuccino is ready, you can add some sugar or Coco powder if you like it.
Note: After the steam stops spraying, please clean the steam pipe
assembly immediately and discharge the milk in the pipe to prevent the
milk froth from scaling on the pipe wall. During the operation, due to the
high surface temperature of the steam pipe, be sure not to be scalded.
D. MAKING HOT WATER
1. Put a container under hot water outlet；
2. When all indicator lamp always keep on, Open steam knob, rotate it to the
maximum position, hot water will be come out from hot water pipe
immediately; In the process of making hot water, the single-cup coffee
indicator“ ” Breathing light on;
3. When the hot water reaches the required amount, turn the "steam knob"
clockwise to the off position, and the hot water stops flowing out.
Reminder: The hot water function can also be used to quickly cool down
the coffee machine.
Note: When using, be careful of the hot parts of the machine. Especially
the water outlet (funnel holder), hot water nozzle and steam pipe. When
operating, please do not put your hands on the above parts for any reason.
E. HEATING LIQUID (Steam function)
1. Use a stainless steel cup, pour cold liquid to 1/2 cup;
Note: Cup diameter should not less than 70 ± 5mm. Because it is heated by
steam to avoid liquid overflows or spills when steam is released.
2. Touch steam button“ ”, it starts preheating, the single and double cup
coffee indicator lights go out, then steam indicator lamp is flashing,
preheating will be finished after steam indicator lamp light on.
3. Put a cup under steam nozzle，let steam nozzle insert into the liquid;
4. Turn on steam knob, release steam.
5. Turn off the steam knob when desired temperature is reached, now steam
is stopped.
Note: Clean steam nozzle immediately after use, to prevent milk scaling.
Caution high temperature of hot water outlet when in use.
INDICATOR TIPS
Single-cu
p Coffee
Indicator
Double-c
up Coffee
Indicator
Steam
Indicator
Cause Solution
Flashing Flashing Flashing
Coffee and hot water
is pre-heating
/
Lights on Lights on
Lights
on
Coffee and hot water
pre-heating finished
/
Breathing
light on
Lights
off
Lights
off
Making single cup
coffee or water
/
Lights
off
Breathing
light on
Lights
off
Making double cup
coffee
/
Lights
off
Lights
off
Flashing Steam is pre-heating /
Lights
off
Lights
off
Lights
on
Steam pre heating
finished
/
Lights
off
Lights
off
Breathin
g light
on
Making steam /