14
Activating/Deactivating Standby mode
Press and hold the Manual button at the laser or remote control for 3 seconds activates the Standby mode.
The self-leveling will be stopped and the beam will be turned off while the HI alert is still active.
The display shows Standby and the HI/MAN-LED flashes red every 5 seconds.
To deactivate Standby mode and restore full operation of the laser, press and hold the
Manual button at the laser or remote control again for 3 seconds.
Line Scan - Vertical Setup
When setting up the unit vertical, Line Scan centers the rotor horizontally and can be used to align the laser
reference to a desired line position. Line Scan can be activated as a standard feature as well as using the menu.
Pressing and releasing the Left/Right buttons simultaneously starts Line Scan while the rotor checks
the limits of the X- axis (all laser LEDs are turned off) and stops at the center position.
Pressing the Manual button stops the movement and changes the unit into manual mode.
Corrections left and right can be done using Left/Right arrow buttons.
Press and release the Manual button to change the unit back to full automatic mode.
To Next Page
Loading...
Need help?
General
