Using the optional HL760 receiver
To pair the HL760 receiver with the transmitter
Make sure the transmitter is turned off.
First, turn on the receiver, then press and hold the Scroll up (A) and Scroll down (B) buttons for two seconds.
After two seconds, the display shows MENU first, then RDIO
Press and release the Enter button (C) – display shows the current radio mode.
If not already set to LS, press Units (C) button (current mode flashes) and then press Deadband (A) or Audio
button (B) until LS is displayed.
Press Units (C) button again to enter selection.
Press and release the Audio (A) button – display shows PAIR.
Press the Units (C) button again – the display shows PAIR and a rotating bar.
Then press and hold the Manual button and turn on the transmitter (Battery LED flashes fast).
After completing PAIR, OK will be displayed.
The LL300S pairs now automatically with the new receiver and turns back to the standard function.
Press and release the HL760 Power button two times to exit the menu at the receiver.
A laser symbol and an antenna is lit to confirm the receiver is ready for communication
with the laser.
Fingerprint function at the HL760 receiver
Fingerprinting makes sure the HL760 detects only the laser beam of the paired tarnsmitter.
Laser fingerprinting is automatically activated after a HL760/HL760U has been paired with the LL300S.
To recognize an ignore laser strikes from other than the paired transmitter takes typically 5 seconds;
sometimes few seconds more.
15
or
or
A
B
C
To Next Page
Loading...
Need help?
General
