GETTING STARTED
CONNECTING THE JSBW-210 EVICES
your television or
TO EXTERNAL AUDIO D
You can connect the JSBW-210 audio input to the audio output of
DVD Player. Please see figure below.
OTE:
sure that the power is turned off when connecting or disconnecting the other
ded AC adaptor with 18V
N
1. Make
devices. Make sure that the other devices are connected to the correct terminals.
2. This unit is not magnetically shielded and may cause color distortion on the screen
of some TVs or video monitors. To avoid this, you may need to move the unit further
away from the TV or monitor if unnatural color shifts or image distortion occurs.
ONNECTING THE AC POWERC
This unit operates using the inclu
1.3A (center-positive
) output, and is compatible with standard 120V~ 60Hz AC household power
the the DC Plug of the AC Adaptor into the DC IN jack on the back of the unit. 1. Insert
Plug the AC Adaptor into a standard 120V~ 60Hz AC wall outlet.
2. Tap the Power /Standby button on remote control or press and hold the
/MODE on main unit to turn on the unit. Mode LED Indicator changes color from
red to relative mode.
3. Tap the Power /Standby button on remote control or press and hold the
/MODE button on the main unit to turn the unit into standby mode after you finish
listening.
REMOTE CONTROL BATTERY INSTALLATION
y (included). To activate
hen the operation of the remote control becomes intermittent or
battery.
The remote control operates on one CR2025 batter
the remote control, remove the insulation tab inserted in the battery
compartment. To remove the tab, pull it in the direction of the arrow in the
illustration as
shown.
W
unsatisfactory, replace the original battery with a new 3-volt lithium
E9
To Next Page
Loading...