Spectrum Digital XDS510USB - User Manual

1
XDS510USB JTAG Emulator
Installation Guide
IMPORTANT INFORMATION
About This Installation Guide
This Installation Guide is for the XDS510USB Emulator product. The XDS510USB Emulator
is a module to be attached to a PC for hardware engineers and software programmers to develop
DSP applications.
The text paragraphs in this Guide are very important for proper device functioning and for
preventing any possible damages on the XDS510USB Emulator device and project target board.
These paragraphs are shaded as in the following example. Please carefully read each of the
shaded text.
This is an example of a very important text paragraph mentioned above.
Introduction
Overview
XDS510USB Emulator is designed to use with digital signal processors (DSPS) operating at
1.0-5.0 volts. The emulator itself is a bus-powered USB device. It is fully plug and play
compatible and is fully powered by the host computer’s USB connection. The XDS510USB
Emulator operates with TI Code Composer Studio IDE debug tool and is fully compatible with
windows 98/SE/ME/2000/XP/VISTA.
Features
XDS510USB Emulator has the following features:
● Supports Texas Instruments DSP with a JTAG (IEEE1149.1) interface: C2000, C5000,
C6000 ,OMAP platforms.
● Supports Texas Instruments Code Composer Studio.
● Supports 1.0-5.0 volt DSP devices.
● USB compatible. Simple Connection, fully Plug-and-Play compatible-no jumpers, noswitch
settings.
● Hot pluggable
● Power provided by USB bus , no additional power supply is required.

Summary

Important Information

About This Installation Guide

Provides essential information and warnings for the XDS510USB Emulator Installation Guide.

Introduction

Overview

Describes the XDS510USB Emulator's design, compatibility, and power source.

Features

Quick Installation

Quick Install Procedures

Outlines the step-by-step process for quickly installing the XDS510USB Emulator.

XDS510 USB JTAG Emulator Kit Contents

Lists the items included in the XDS510USB JTAG Emulator kit.

Installation Requirements

Specifies the necessary hardware and software prerequisites for installation.

Supported Operating Systems

Lists the operating systems compatible with the XDS510USB Emulator.

Detailed Installation

What you will need

Lists all items required to install and run the XDS510USB JTAG Emulator.

The Hardware Installation

The USB Device Drivers Installation

Driver installation for Windows 2000;XP

Details the steps for installing USB device drivers on Windows 2000/XP systems.

Installing the XDS510 USB software

CCS Emulate Configuration

Setup

Guides launching Code Composer Studio setup and selecting target configurations.

Important Note on Pin Orientation

Spectrum Digital XDS510USB Specifications

General

Type	Emulator
Supported Devices	Texas Instruments DSPs
Interface	USB
Power Supply	USB Powered
Host Interface	USB
Debug Interface	JTAG
Debugging Support	Real-time debugging
Operating System Support	Windows
Operating System Compatibility	Windows
Target Voltage	3.3V, 5V
Compatibility	Texas Instruments Code Composer Studio