Spectrum Oxford Series User Manual

Oxford Series Assembly Instructions
3
CASTERS/GLIDES
2
1
4
6
5
7
ARM
S
8
1) Remove base, back, pneumatic cylinder,
casters/glides, and seat from box.
2) Insert casters/glides 2 on base 1 . Using
pressure, push the casters/glides into the
base making sure they are all the way in.
3) Place base 1 with legs on hard level surface.
4) Insert cylinder 3 into center hole of base and
lightly push down.
5) (Optional) Arm rests 8 are factory installed
for shipping. Use enclosed allen wrench to
adjust width of arms: loosen screw, adjust
arms, tighten screw.
6) Turn seat upside down and place on the
edge of a table to slide the back bar into
position.
7) Attach back bar to seat 4 using 4 bolts
and 4 washers. Firmly tighten with enclosed
allen wrench.
8) Turn assembled seat over and align the
center hole on the bottom of the seat with
the top of the pneumatic cylinder and lightly
push down. With the weight of your body,
carefully sit on the seat. This will press the
base, pneumatic cylinder, and seat together.

Spectrum Oxford Series Specifications

General

Brand	Spectrum
Model	Oxford Series
Category	Indoor Furnishing
Language	English