To Next PageTo Next Page
Need help?Do you have a question about the Spectrum Oxford Series and is the answer not in the manual?
General| Brand | Spectrum |
|---|---|
| Model | Oxford Series |
| Category | Indoor Furnishing |
| Language | English |
Remove base, back/back bar, pneumatic cylinder, casters/glides, and seat from the box.
Insert casters or glides onto the base using firm pressure.
Slide optional foot ring over pneumatic cylinder and tighten the knob.
Place the base with legs on a hard, level surface.
Insert pneumatic cylinder into the base center hole and push down lightly.
Turn seat upside down and slide the back bar into position.
Loosen knob, slide back bar into seat mechanism, push until click, then tighten knob.
Align seat center hole with cylinder top, push down, and sit to secure.
While not seated, pull up on the lever to raise the chair height.
While seated, pull up on the lever to lower the chair height.
Remove base, back, pneumatic cylinder, seat, foot ring, and casters/glides from box.
Place base upside down and insert casters/glides into the base.
Slide optional foot ring over pneumatic cylinder and tighten the knob.
Flip base, insert pneumatic cylinder into base center hole with colored button up.
Align seat center hole with cylinder top, push down, and kneel on seat to secure.
Depress spring-loaded button on chair back bar to lift the back release.
Push bar down until it clicks, then adjust seat back height and lock.
Use control lever to adjust seat back angle and push release down to lock.
Take weight off chair, pull lever on underside of seat, and adjust height.
While seated, lift up on the lever on the underside of the seat.
Remove two bolts from the arm component.
Align the open slot of the arm cup with the bottom of the arm.
Align arm cup slot with mounting bracket on upside-down seat, attach with bolts.
Loosen lever, slide arm in or out to desired location, then tighten lever.
Pull up on button, adjust arm to desired height, then release button.
Remove base, pneumatic cylinder, seat, foot ring, and caster/glides from box.
Place base upside down and insert casters/glides.
Slide optional foot ring over pneumatic cylinder and tighten knob.
Flip base, insert pneumatic cylinder into base center hole with colored button up.
Align seat center hole with cylinder top, push down, and sit to secure.
Take weight off stool, pull ring on underside of seat, and adjust height.
While seated, lift up on the ring on the underside of the seat.
Remove base, back, pneumatic cylinder, casters/glides, and seat from box.
Insert casters/glides on base using pressure to ensure they are fully in.
Place the base with legs on a hard, level surface.
Insert the pneumatic cylinder into the center hole of the base.
Use allen wrench to loosen screw, adjust arms, and tighten screw for width.
Turn seat upside down and place on table edge to slide back bar into position.
Attach back bar to seat using 4 bolts and washers, tighten firmly.
Align seat center hole with cylinder top, push down, and sit to secure.
Remove base, back, pneumatic cylinder, casters/glides, and seat from box.
Insert casters/glides on base using pressure to ensure they are fully in.
Place the base with legs on a hard, level surface.
Insert the pneumatic cylinder into the center hole of the base.
Use allen wrench to loosen screw, adjust arms, and tighten screw for width.
Turn seat upside down and place on table edge to slide back bar into position.
Attach back bar to seat using 3 bolts and washers, tighten firmly.
Attach headrest to top of seat back using allen wrench and screws.
Align seat center hole with cylinder top, push down, and sit to secure.
