SpeechWare SpeechMatic User Manual (English)

To Next Page

MuliAdapter Guide

Setting up your SpeechWare MultiAdapter:

1. Remove items numbers 1 – 3 from the packaging. Item #3 (the extension cable) is included to prevent the MultiAdapter

(USB soundcard) from blocking an adjacent USB port but is not required.

2. Insert your analog microphone into the pink microphone input jack on #1. Note that the microphone input jack includes a

microphone symbol to prevent possible confusion.

3. Insert #1 into #3 (extension cable) if you don’t want to block an adjacent USB computer port. You can optionally leave the

extension cable out if you don’t need it. Plug your MultiAdapter USB soundcard into a dedicated USB port. Note that if

you’re using a desktop computer we do not recommend using a front or side port because they are split from the rear

ports. We additionally don’t recommend using a USB splitter. If possible, use a dedicated rear desktop computer USB

port. Note that this isn’t an issue with notebook, all-in-one and tablet computers which only utilize direct USB ports.

4. When inserting into a USB port, waking up your computer from hibernation or booting up your computer the power

button will turn green to signify that is receiving power in green light mode, with all built-in features (auto gain

control/auto EQ etc.). A push of the button will mute the MultiAdapter soundcard. Holding down the power button for

approximately 3 seconds will trigger the blue light mode which turns the unit on but bypasses all internal features. The

blue light mode is designed for overly sensitive microphones and VoIP use.

Need help?

Do you have a question about the SpeechWare SpeechMatic and is the answer not in the manual?

SpeechWare SpeechMatic Specifications

General