SpeedTech Lights STL Boss User Manual

STL Boss
SUMMARY:
 Powered by 12V
 Clear sound frequency
 Control Unit Dim: 5”L x 3” W x 1” H
 Amplifier output power of 300-Watts
 Speakers not included in original set
 Optional Flat brackets included for mounting unit
 Microphone and cable included with siren
 Optional Speaker Dim: 8” L x 7” W x 5” H
 Allows for independent siren tones for each speaker
INSTALLATION INSTRUCTIONS：
1. The Boss siren system comes with all cabling needed for installation
2. This system will include a telephone cable (one long and straight and one curly); these
will connect with an adapter, also included.
3. It will also include (2) long red cables and (2) long black cables for power, and a gray
connector with (2) orange, (2) green, (1) gray, and (1) yellow wires.
4. Connect the phone cable to the plug in on the power supply labeled “Signal Socket”.
5. Then connect the Gray connector into the power supply to the right of the phone cable.
6. From the gray connector, you will wire the (2) orange wires to one speaker, and the (2)
green wires to your second speaker. (The yellow and gray wires are for international use).
7. You will then connect the power cables, (2) red and (2) black, to the power supply. Each
cable includes a connector at one end for you to screw to the power supply.
8. Connect the (2) black cables to the (2) negative slots on the power pack and the (2) red
cables to the (2) positive slots.
9. Once you have connected all the wires correctly, wire up your (2) red power cables to the
positive on your battery and your (2) black cables to the negative on your battery.
10. This will allow you to give power to the whole system.

SpeedTech Lights STL Boss Specifications

General

Brand	SpeedTech Lights
Series	STL Boss
Housing Material	Aluminum
Lens Material	Polycarbonate
Waterproof Rating	IP67
Voltage	12V
Mounting Type	Permanent or Magnetic

Summary

STL Boss Installation Instructions

Connect Phone Cable to Power Supply

Connects the phone cable to the power supply's "Signal Socket".

Connect Gray Connector to Power Supply

Connects the gray connector to the power supply.

Wire Speakers

Wires orange wires to one speaker and green wires to the second speaker.

Connect Power Cables to Power Supply

Connects red and black power cables to the power supply.

Connect Power Cables to Power Supply Slots

Connects black cables to negative and red cables to positive slots.

Connect Power Cables to Battery

Connects power cables to the battery's positive and negative terminals.

Connect Phone Cable and Microphone to Faceplate

Connects phone cable and microphone to the faceplate.

Power On and Operate Unit

Turns on the unit and powers its functions via the faceplate.

Install Faceplate in Console Bracket

Installs faceplate into a console bracket using corner holes.