Hydro Press
page 3 of 12
1 General information
Dear Customer,
You have purchased a new product from SPEIDEL.
Thank you very much for your trust. When it comes to our products, quality and
functionality are of our utmost concern.
Intended use:
The Hydro Press is designed and manufactured for pressing (juice extraction) of pitted
and ground or crushed fruit, such as grapes, apples, or pears. The press is only suitable
for pressing with water pressure (do not use air pressure).
Operating instructions:
In order to ensure your new Hydro Press will work reliably and safely from the first time
you use it and throughout its entire operating life, we have written these operating
instructions. Please read them carefully before using the product for the first time. If you
follow these tips and instructions carefully, the press will work to your utmost
satisfaction and will last you for a long time to come. Should you decide to pass this
product on to a third party, please ensure to hand over the operating manual as well.
Declaration of Conformity
SPEIDEL Tank- und Behälterbau GmbH hereby declares that the “Hydro Press” product
mentioned in these instructions, and to which this declaration applies, complies with the
requirements of the European guidelines.
Manufacturer:
Speidel Tank- und Behälterbau GmbH
Krummenstrasse 2
D-72131 Ofterdingen
Germany
www.speidels-hausmosterei.de
www.speidel-behaelter.de
2 Safety instructions
General safety instructions:
The Hydro Press may only be operated with water pressure, never use air pressure -
Risk of explosion!
Important: In order to prevent an air buffer inside the diaphragm, press down the vent
plunger until the air has fully escaped and water leaks out of the unit.
The rubber diaphragm must be protected from sharp objects and exposure to the sun
(may cause brittleness).
Please provide a secure installation, placing the product on a flat and stable surface.
When using the Hydro Press 180L, a sudden pivoting motion should be avoided.
Ensure that the locking pin engages into place after pivoting and while the unit is in a
tilted position. A clicking noise should be audible.
To Next Page
Loading...