EasyManuals Logo

Spektrum AR6610T User Manual

Spektrum AR6610T
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
EN
8
Receiver Power System Requirements
Inadequate power systems that are unable to provide the necessary minimum
voltage to the receiver during fl ight have become the number one cause of
in-fl ight failures. Some of the power system components that affect the ability
to properly deliver adequate power include:
Receiver battery pack (number of cells, capacity, cell type, state of charge)
The ESC’s capability to deliver current to the receiver in electric aircraft
The switch harness, battery leads, servo leads, regulators etc.
The AR6610T has a minimum operational voltage of 3.5 volts; it is highly
recommended the power system be tested per the guidelines below.
Recommended Power System Test Guidelines
If a questionable power system is being used (e.g. small or old battery,
ESC that may not have a BEC that will support high-current draw, etc.), it is
recommended that a voltmeter be used to perform the following tests.
View the receiver voltage during this test on your transmitters telemetry screen,
load the control surfaces (apply pressure with your hand) while monitoring the
voltage at the receiver. The voltage should remain above 4.8 volts even when
all servos are heavily loaded.
How QuickConnect
Technology Works
When the receiver voltage drops below 3.5 volts, the system ceases to
operate.
When power is restored, the receiver immediately attempts to reconnect.
If the transmitter was left on, the system reconnects typically in about
4/100 of a second.
QuickConnect is designed to allow you to fl y safely through most short duration
power interruptions, however, the root cause of these interruptions must be
corrected before the next fl ight to prevent a crash.
NOTICE: If a brownout occurs in fl ight it is vital that the cause of the
brownout be determined and corrected.
IMPORTANT:
When using Y-harness or servo extensions with Spektrum
equipment, do not use reversing harnesses. Using reversing Y-harnesses or
servo extensions may cause servos to operate erratically or not function at all.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Spektrum AR6610T and is the answer not in the manual?

Spektrum AR6610T Specifications

General IconGeneral
Quantity per pack1 pc(s)
Voltage9 V
TypeRadio-Controlled (RC) Model Parts
ModulationDSM2, DSMX
Product typeReceiver
Product colorMulticolor
Antenna length186 mm
Channels quantity6 channels
Weight and Dimensions IconWeight and Dimensions
Depth49.8 mm
Width23.34 mm
Height15.02 mm
Weight12 g

Related product manuals