EN
22
Problem Possible Cause Solution
Aircraft will not
connect (after
binding) to
transmitter
Transmitter too near
aircraft during connecting
process
Move powered transmitter a few
feet from aircraft, disconnect
and reconnect flight battery to
aircraft
Aircraft or transmitter is
too close to large metal
object, wireless source or
another transmitter
Move aircraft and transmitter
to another location and attempt
connecting again
Bind plug left installed in
bind port
Rebind transmitter to the aircraft
and remove the bind plug
before cycling power
Aircraft bound to different
model memory.
Select correct model memory
on transmitter
Flight battery/Transmitter
battery charge is too low
Replace/recharge batteries
Transmitter may have
been bound to a different
aircraft using different
DSM protocol
Rebind aircraft to transmitter
Control surface
does not move
Control surface, control
horn, linkage or servo
damage
Replace or repair damaged
parts and adjust controls
Wire damaged or
connections loose
Perform a check of wires and
connections, connect or replace
as needed
Transmitter is not bound
correctly or the incorrect
model was selected
Rebind or select correct
airplanes in transmitter
Flight battery charge
is low
Fully recharge flight battery
BEC (Battery Elimination
Circuit) of the ESC is
damaged
Replace ESC
To Next Page
Loading...
Need help?
General
