EN
13
1. Output- The failsafe can be controlled during bind (SmartSafe + hold
last or Preset) or custom.
2. Bind Plug- Binding will set the failsafe behavior as described in the
receiver manual.
3. Custom- Each output can be selected to Hold Last or Preset. When
selected to Hold Last, the selected output will hold the last position in
the event of a failsafe. When selected to Preset, the output selected will
return to the position set during bind or selected in this menu.
4. Position- Adjusting this value adjusts the Failsafe position for the output.
This position setting is only relevant if a channel is set to Preset.
Capture Failsafe Positions
This menu will capture the current transmitter positions for each output and set
them to the Failsafe positions.
Factory Reset
Reset the receiver and AS3000 settings back to the default settings and clear
all programming.
NOTICE: Performing a factory reset will clear all settings from the model.
TIP: The receiver can be forced to defaults by plugging in a bind plug, and
power cycling 5 times in a row. All the LEDs will start blinking simultaneously
to indicate that defaults have been set. This will help reset settings in case
a wrong orientation is set, and the receiver can’t initialize to use to forward
programming factory reset.
To Next Page
Loading...
Need help?
General
