Select Thermal mode using F-mode switch (position 2). Repeat adjustment similar to Launch mode
Note: Offset settings depends how your aileron servo horns are mechanically setup. Adjust accordingly.
Do try playing around with the rates as it may differ from model to model.
Flap/Elevator Mix
After the flaperons have been setup, the elevator needs to compensate to prevent the DLG from
ballooning up when the air brakes are activated. In the Mixing menu, go into Flp>Ele mix to setup the
elevator compensation. The settings below should be good enough to start with final values should be
done at the field.
To Previous Page
Loading...
Need help?
General
Weight and Dimensions
