Speler SP-LED32 - BASIC OPERATIONS

15
MAKE SURE ALL THE EQUIPMENTS AND POWER CORD
ARE CONNECTED PROPERLY AND THE UNIT IS SET IN CORRECT
MODE BEFORE OPERATING.
- Press POWER button on the unit or remote control to power ON the unit (indicator
will glow blue); press it again to power OFF (standby mode) the unit (indicator will
glow red).
- Press SOURCE button on the unit or remote control to switch the unit to TV mode.
SELECT DESIRED PROGRAM
1. Press CH+ button to play next channel.
2. Press CH- button to play previous channel.
3. Press number buttons on the remote control directly to select desired program.
Example : Track 9, press ＂9＂, three seconds later it will turn to track 9 automatically, or
press ENTER button to confirm directly.
Track 12, press ＂1＂ and ＂2＂, three seconds later it will turn to track 12 automatically,
or press ENTER button to confirm directly.
NOTE : If one frequency dot has more than one channel, for example, track 15-3,
press ＂1＂ and ＂5＂, then press ＂ ＂ and ＂3＂, three seconds later it will turn
to track 15-3 automatically, or press ENTER button to confirm directly.
VOLUME CONTROL
- Press VOL+ or VOL- to adjust the level of current volume.
Available range: 0-100.
MUTE CONTROL
- Press MUTE button to mute the sound, press it again to turn on the sound.
SOURCE SETTING
- Press SOURCE button on the unit or remote control to display the input source list.
- Press UP or DOWN navigation button to select desired input source, and then press OK
button to confirm selection.
Available options: TV, AV, YPbPr, HDMI 1/2/3, VGA, USB/Media.
PICTURE MODE
- When watching an available program, press PICTURE MODE button on remote control
repeatedly to select desired picture mode directly.
Available options: User, Standard, Dynamic, Soft, Power Saving.
BASIC OPERATIONS