To Next PageTo Next PageHow to fix insufficient flow rate in my SPERONI CAM 100 HL Water Pump?
If your SPERONI Water Pump has an insufficient flow rate, consider the following: * Check that the suction lift isn't too high. * Clean the suction rose if it's dirty. * Lower the suction valve if the water level is falling quickly. * Clean the pump to remove any foreign bodies and replace any worn parts that may be reducing the flow rate.
What to do if my SPERONI CAM 100 HL Water Pump won't suck?
If your SPERONI Water Pump isn't sucking, here's what you can check: * Ensure the suction valve is submerged in water, at least 30 cm deep. * Pour water into the suction union to prime the pump chamber. * Inspect the suction pipe for any air leaks. * Clean the suction valve to ensure it's airtight. * Clean the suction rose if it's dirty. * Verify that the maximum suction lift hasn't been exceeded.
Why won't my SPERONI CAM 100 HL Water Pump motor start?
If the motor of your SPERONI Water Pump won't start, consider these possible causes: * **No mains voltage:** Check the voltage supply. * **Pump impeller jammed:** Dismantle the hydraulic section to inspect the impeller, ensure it rotates freely, and reassemble carefully. * **Thermostat detached:** Dismantle the hydraulic section to inspect the impeller, ensure it rotates freely, and reassemble carefully.
What to do if thermal cutout switches off SPERONI CAM 100 HL?
If the thermal cutout is switching off your SPERONI Water Pump, it's likely due to: * Motor overload. * Excessive friction caused by foreign bodies. In both cases, you should eliminate any foreign bodies that may be causing the issue.
What to do if my SPERONI CAM 100 HL Water Pump motor will not start?
If your SPERONI Water Pump's motor won't start, first, check if there is mains voltage. If voltage is present, the pump impeller might be jammed or the thermostat detached. In such cases, dismantle the hydraulic section to check if the impeller rotates freely, then carefully reassemble it.
Why SPERONI Water Pump will not suck?
If your SPERONI Water Pump isn't sucking water, ensure the suction valve is submerged at least 30 cm in water. Also, check if the pump chamber has water; if not, pour water into the suction union. Air in the suction pipe, a non-airtight suction valve, or a dirty suction rose can also be causes. Clean these parts as needed and verify that the maximum suction lift hasn't been exceeded.
How to fix insufficient rate of flow in SPERONI CAM 100 HL Water Pump?
If your SPERONI Water Pump has an insufficient rate of flow, check that the suction lift isn't too high and that the suction rose is clean. If the water level is dropping quickly, lower the suction valve. Foreign bodies might also be reducing the pump's flow rate, so clean the pump and replace any worn parts.
General| Pump type | Centrifugal |
|---|---|
| Outlet connection | 1" |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Power | 1 HP |
| Inlet connection | 1 inch |
| Liquid temperature | 0 - 35 °C |
